The role of Applied Materials in the upcoming 3D stacking revolution (part 2)

3D stacking

So where Applied Materials see their strength in this process?

One of the areas where Applied Materials can work well with is the creation of the structure itself as the requirement for high precision manufacturing of the staircase structure leaves, as said, very little room for error. While an inferior process may lower the yield of a planar structure of just one or two percentage points, the same inferior process may lower the overall yield of a 16 or 32-layered structure considerably.

Another advantage for Applied Materials with 3D stacking is that the lithography part of the equation, while still important, is somehow less crucial to the final result as a 3D stacked structure built with 45nm lithography technology may have similar performance than a planar structure built with 22nm lithography. This would be good news for Applied Materials, who has more control on the etching and stacking side of the process and less control on the lithography and patterning side.

However, a loosening on tolerances on the lithography part comes with stricter tolerances on the etching part due to the precision needed to align and etch each layer: but here is where Applied Materials believes to have a competitive edge over other companies

One of the areas where Applied Materials claims to be able to offer improvements to the current process is with high aspect ratio etching. With 3D stacked ICs it is necessary to etch vias with aspect ratio up to 70:1 or higher, but problems of charged particles need to be carefully controlled on this regard.

New technological improvements such as the ability to control source and bias of the etching machine are aimed to solve the problem of charge particles which could make the creation of straight vias impossible. In addition to this, another improvement is the ability to etch separate layers without having to load and upload the wafers in between, are claimed to be real breakthroughs aimed at bring forward 3D stacking to IC manufacturing.

But etching vias with high aspect ratio is not the only issue: being able to etch them fast enough is also a must. This means that it is necessary to apply top layers with high selectivity and thick enough so that the underlying layers will be etched fast and deep enough. Moreover, a highly anisotropic process is needed.

Lack of high selectivity would mean that the mask layer would have to be very thick to be able to etch deep enough and this may result in impractically thick mask layers. Lack of a highly anisotropic process would mean side walls not vertical enough to be able to reach the required depth for the vias.

Another potential show stopper is the requirement of strict tolerances with thin film thickness and therefore ability to be able to deposit layers with less than one percent variation in thickness along the whole surface of the wafer and among different layers of the same structure is critical.

In conclusion, creation of 3D structures involves many more steps than simply exposure, develop, etch and resist removal. In addition to this, focus in the process moves away from the sole lithography as other steps of the process, namely deposition and etching, become critical. It remains to be seen if Applied Materials and the other big guys involved in the industry will be able to deliver the new solutions that are needed to move from planar to 3D ICs, still going 3D may be the only way for the whole semiconductory industry to keep pace with the continuous trend of increase in performance for ICs due to the numerous delays that have affected EUV and other litho technologies that were supposed to extend Moore` s Law life until the 2020s at earliest.

Note:
If you are interested in our Nanoimprint lithography, please visit our Nanoimprint lithography service page.

Subscribe to our newsletter to receive our new articles directly in your mail box.

If you liked this article, please give it a quick review in StumbleUpon, Facebook or Pinterest.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title="" rel=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>